PlugGuard electrical outlet cover. C hild safety device and an energy saving device for any standard 2 or 3 prong grounded duplex electrical outlet. Two spring loaded sliding plates move up or down to use outlets. Heavy duty plastic covers have recessed outlet openings. Doors automatically close when plug is removed. Replace existing outlet plate: foam backing switch gasket also provides a tight seal around the outlets to prevent drafts that increase air conditioning or heating bills.
Dimensions: 3 inches wide by x 4.75 inches high x 5/8 inch thick.
Two sliding doors, bottom moves down; top moves up. Each door is 1.75 inches wide and 2 inches high
Doors open only wide enough to expose the actual outlet: about 1 inch.
Fits all standard 2 and 3 prong plugs. Over-sized plugs will not fit into either opening.
Thickness: Slightly thicker than a standard plate cover.
Warranty: Free from defects in material and workmanship for one year by manufacturer.
Made in China
Plug Guard Installation Instructions:
Shut off Circuit Breaker at Fuse Box
Use a screw driver to remove existing wall plate by turning screw counter-clockwise.
Position Plug Guard in place and turn screw clock-wise to secure without over tightening.
Turn power back on and use as needed.
The sliding door outlet cover is about the same size as a standard outlet cover but it is thicker. When you slide a door open, there is an opening that is about 1 inch high and wide enough for all standard 2- and 3-prong plugs. Over-sized plugs will not fit into either opening.