RoadWorthy 12V Auxiliary CarHeaters or Truck Heaters Uses Engine Power
Case of 6. 12 Volt ceramic RoadWorthy truck heaters. Extra extra heat in trucks, RV's, etc. Note: this is an auxilliary back seat heater, not a primary car heater. Heater Hard-Wires, does NOT plug into 12V outlet. Forced air heater uses vehicle power: operates only when engine is running. Backseat heater produces 1100 BTU's instant heat: warms cold areas in any 12 Volt vehicle. Easily installed. Outer housing remains cool during use. Ignition Block: Back Seat Heater operates only when engine is running. Unique cell design: 100% efficient heat transfer to surrounding air.
Roadworthy 12V BackSeat Heater Features:
Draws 25 amps with 300 watt power consumption. Includes a high temperature cut-out recycling limit switch. 20 foot wire harness with in-line 30 amp fuse. Wire connects at lower left back of unit.Includes a universal mounting bracket plus an auxiliary control dashboard on/off switch. Controls are fan, off and heat. The adjustable temperature control is on the unit.
Circular air intake (rear of unit: 4.5 inch circle). Front grill: 4.5 inches wide by 4.25 inches high. Front heat output area: 2.75 x 2.75 inches. Fan rating: 102 CFM.
Assembled in USA.
Dimensions: 5.25" x 7.25" x 8.25". Weight: approx. 6 lb.
Warranty: 2 Years.
Notes On Roadworthy Car Heater:
Not intended to be primary heat source. Air output is 20° to 30° warmer than air input.
Not for use in unsupervised areas such as the bay compartments of RV's: RV dealers only can purchased and install the CARGO HEAT unit, 3000RV
For Heater Operation: Alternator must produce 45 to 40 amps.
Mount: Low on floor, under elevated seats, on wheel wells.
Start vehicle. Turn on heater. Engine MUST run to use heater and fan.
Adjustable temperature control on unit.
12 Volts/300 watts/25 amps. Hard wire installation required.