Box of 3 Black 6 Bar Basic Fixed Mount Guards 22 x 41-58 Inches Made in USA
Locking Channel, mounting screws nor safety release pin is included. Purchase components separately if needed. This is a pack of three Black John SterlingJS-BK-1136-LDB Basic Fixed Mount Window Guards that meet the New Jersey code for non-sleeping room windows. Each black child safetyand security window guard unit is for is 22 inches high and extends from 41 to 48 inches. The John Sterling 1130
Series Child Safety Window Guards are only for Non-Sleeping Areas. These BK window guards are installed as fixed mounts .Install horizontally or vertically to protect double hung windows, sliders or casement windows. Note: Black is a custom color: ships within 2 to 6 weeks.
NOTE: Check with your local building inspection department for window guard requirements for your locality.
New Jersey Law now requires that the window guard covers the entire
lower half of a double hung or single hung window, from the top of the
sill to the bottom half of the upper sash, with less than a 4 inch gap
above and below the guard. Choose BK-1130 series fixed mount window
security guards for Non-Sleeping Room Windows.
John Sterling Security and Child Safety Window Guard 1130 Series Fixed Mount Window Guard Features:
Window Type to Protect: Double hung, sliders or casement windows.
Window Locations: Non-sleeping rooms.
Bar Spacing: 3.5 inches. Exceeds 4 inch recommended safety standard for child window bars.
Bar Diameter: 5/16th Inch.
Mounting Options: Horizontal or vertical installations.
Stackable: Fit units side by side or vertical stack to fit window width or height.
Black . (Black ships within 2 to 6 weeks after order is placed.)
Construction: Steel window guards
Strength Test: Tested to withstand 150 lb. force at maximum extended width.
Operational Type: Fixed mount window guards are NOT removable from window.
Manufacturer: Knape & Vogt, Michigan
Made in USA.
Manufacturers Limited Warranty :
Replacement of any part found defective in material or workmanship.
Warranty is limited strictly to replacement of the defective part and
does not cover any other expenses which may arise in the use or
replacement of such part.
Mounting Options: Recessed or Surface
Mount. Surface Mount burglar bar installation is easier as screws are
easier to drive and less accessible to intruders on the outside.
Tamper Resistant: Option to drill out the Phillips cross slots in each screw to make tamper resistant.
Options: Double Hung, Sliders or Casement windows only. Mount security
bars over both upper and lower window sashes or over lower sash only as
and Window Security Guards when properly installed will tend to
discourage illegal intruders. But no protection is absolute. With
enough time and tools a determined criminal can defeat any barrier.
Installation Requirements :
Install only in solid, non-rotting window tracks. Expand Guard to fit tightly into outside window track.
support Guard in level position NO MORE THAN 4 inches from sill to
upper half of bottom bar. Mark location of holes on each side. Remove
Guard and drill 5/32" diameter pilot holes 1 inch deep.
Re-position Guard and mount with #10 one way screws (included.)
the inner window NO MORE THAN 4 inches above the lower half of the top
bar. Position "L" shaped stops so as to limit the opening above the
Window Guard to a maximum of 4 inches.