Three White 5 Bar Fixed Window Guards Made in USA Meet NYC Codes
5-Bar Non-Opening Window Guards JS-1125 . New York City Approved. For Non-Sleeping Areas. John Sterling Fixed Guards are each 25"H X 23-42" W . Off White. 3 Per Carton.
John Sterling 1120
Series Child Safety Window Guards for Non-Sleeping Areas: These Fixed
Guards are New York City Approved #HDWG 05-87-86 and HDWG-04-93-09
for Installation in Double Hung Style Windows Only.
John Sterling Security Window Guard JS-112 5 Features:
Location of Windows: Not in a sleeping Room, Guards Do Not Open
Specifications of 1125: 4.5 space between bars, 5/16 inch diameter, 5 bars, Expand 23-42 inches. Protects up to 25 Inches High. Steel, Off White, powder coated finish.
Strength Test: Tested to withstand 150 lb. force at maximum extended width.
Manufacturer: Knape & Vogt, Michigan
Made in USA.
Manufacturers Limited Warranty: Replacement
of any part found defective in material or workmanship. Warranty is
limited strictly to replacement of the defective part and does not cover
any other expenses which may arise in the use or replacement of such
Mounting Options: Recessed or Surface Mount.
Surface Mount burglar bar installation is easier as screws are easier to
drive and less accessible to intruders on the outside.
Tamper Resistant: Option to drill out the Phillips cross slots in each screw to make tamper resistant.
Installation Options: Double Hung windows
only. Mount security bars over both upper and lower window sashes or
over lower sash only as desired.
WARNING for Series 1120 Series Sterling Window Guards:
Use of this product
on a fire escape window in New York is illegal, could be a serious
safety hazard and could result in a fine by the Department of
Buildings. Some communities require a quick means of easy escape from
window guards in some applications. Check your local codes.
Sterling Window Security Guards when properly installed will tend to discourage illegal intruders. But
no protection is absolute. With enough time and tools a determined
criminal can defeat any barrier.
Install only in solid, non-rotting window tracks. Expand Guard to fit tightly into outside window track.
Temporarily support Guard in level position NO MORE THAN 4-1/2 inches from sill to upper half of bottom bar . Mark location of holes on each side. Remove Guard and drill 5/32" diameter. pilot holes 1" deep.
Re-position Guard and mount with #10 one way screws (included.)
Raise the inner window NO MORE THAN
4-1/2" above the lower half of the top bar. Position "L" shaped stops so as to limit the opening above the Window Guard to a maximum of 4-1/2.