1123-S Non-Opening Window Guards are NYC Approved for Non-Sleeping Rooms
John Sterling warm white powder-coated steel window guards: New York City approved for non-sleeping areas. JS-1123-S window guards include mounting screws. 15 inches high: expands 14 to 24 inches wide. Barsprotect up to 18 inches. Bar diameter: 5/16 th Inch. Spacing
between bars: 4.5 inches. Tested to withstand 150 lb. force at maximum extended width. Recessed or surface mount. Surface mount installation is easier: screws easier to drive and less
accessible to intruders on the outside. Made in USA.
Non-opening window bars only for non-sleeping areas. Tamper
Resistant: Option to drill out the Phillips cross slots in each
screw. Double Hung windows only. Mount security bars over both
upper and lower window sashes or over lower sash only as desired. Made in USA.
Limited Warranty: Replacement of any part found defective in
material or workmanship. Warranty is limited strictly to replacement
of the defective part and does not cover any other expenses which
may arise in the use or replacement of such part.
John Sterling 1120
Series Child Safety Window Guards are only for Non-Sleeping Areas. These Fixed
Guards are New York City Approved #HDWG 05-87-86 and HDWG-04-93-09
for use in Double Hung Style Windows Only. NOTE:
For sleeping area window guard installations in New York City, check
with your local borough for code requirements.
for Series 1120 Series Sterling Window Guards:
of this product on a fire escape window in New York is illegal, could
be a serious safety hazard and could result in a fine by the
Department of Buildings. Some communities require a quick means
of easy escape from window guards in some applications. Check
your local codes.
only in solid, non-rotting window tracks. Expand Guard to fit
tightly into outside window track.
support Guard in level position NO MORE THAN 4-1/2 inches from sill
to upper half of bottom
bar . Mark location
of holes on each side. Remove Guard and drill 5/32"
diameter. pilot holes 1" deep.
Guard and mount with #10 one way screws (included.)
the inner window NO MORE THAN 4-1/2" above the lower half of
the top bar. Position "L" shaped stops so as to
limit the opening above the Window Guard to a maximum of 4-1/2.