Width: 26 .5 " (67 cm)- 41.5" (105 cm)
 Height: Installed Average 29.5" (75 cm)
PET & KID GATE - MG-25
NO ASSEMBLY REQUIRED!
STEPl
STEP 2
fkFb
STEP 3
FIG A
Loosen width adjustment set screws enough with alien wrench to allow gate to expand.Keep plastic shipping tabs in place. Tabs will be discarded and set screws tightened after final adjustments.
PARTS
Place latch bracket on latch rod, as shown with bracket snug against bottom of eye bolt. Expand gate so that latch bracket is against mounting surface and mark holes (figure C). Separate bracket from rod and mount as marked (figure D). Close gate and make final adjustments according to note below. TO CLOSE gate, raise latch rod, push against pendulum, and drop into holes. TO OPEN gate, we suggest that you use thumb to push pendulum to the side while raising latch rod with finger.
With gate in open position, place gate on carton to establish a height of approximately 1 3/4" above floor. A height of 1 1/2 to 2 1/4 inches is acceptable. If mounted in doorway, mount gate on doorstops so that door stop will not interfere with the safety pendulum and allow for two-way operation. Use short screws for doorframes, etc., and longer screws to reach a stud through dry wall. Be sure gate is level before proceeding. See Photo for leveling adjustment. Note: For large pet use only, gate may be mounted as high as 4 inches off floor.
Safety Pendulum
Hole to attach Width Adjustment width extension Set Screw
Leveling Adjustment Set Screw
TPX-1
Attachment
Hole
\ Upper Hinge Bracket with Telescoping Tube
Latch Rod
Adjustal Eyebol
IMPORTANT - One-Way Operation
If gate is mounted at top of stairs, install one-way safety bracket at lower hole of latch bracket with safety bracket towards stairs (figure E). This prevents opening of gate over stairway for safety purposes.
Lower Hinge Bracket (fixed)
*NOTE:
The bottom hole in the latch bracket is slotted for vertical alignment. Lateral alignment for latch rod can be accomplished with nuts on eyebolt. To level gate, adjust telescoping tube attached to upper hinge bracket. After final adjustment, loosen set screws, one at a time and remove shipping tab. Discard tab and retighten set screws. When tightened, set screws will be flush or slightly recessed. Check now and periodically that all nuts, screws, etc., are tightened securely.
4\ 1AI A D Kl IM ^ - T0 PREVENT SERIOUS INJURY OR DEATH, SECURELY INSTALL GATE OR ENCLOSURE AND USE ACCORDING TO MANUFACTURER'S INSTRUCTIONS. NEVER USE WITH A CHILD ABLE x VVRlAlN I IN O -TO CLIMB OVER OR DISLODGE/OPEN THE GATE ENCLOSURE. NEVER LEAVE CHILD UNATTENDED. USE ONLY WITH THE LOCKING/LATCHING MECHANISM SECURELY ENGAGED.