Gas Alarm Solenoid Valve Shuts Off Gas Appliances.

Gas Leak Detector Alarm with Gas Valve Control

	Gas Leak Detector Alarm with Valve Control (Plug In with Battery Backup) from CCI.
	Combustible Gas Detectors from SafeHomeProducts.
	Carbon Monoxide Detectors from SafeHomeProducts.

Gas Leak Detector Alarm Series 7600 Controls Gas Valve

CCI Series 7600 Combines A Gas Alarm with a Solenoid Controlled Gas Valve to Shut Off Gas When a Dangerous Gas Leak Occurs. A Backup Battery Gives Up to Five Hours of Additional Gas Safety.

Gas Leak Detector Alarm Series 7600 Controls Gas Valve (120V Plug In with Battery Backup)

Series 7600 Boxed Kit Includes:

Methane or Propane Detector
Gas Control Valve (Professional installation recommended)
Inside Wall Housing holds Battery
Standard AC Adaptor
Backup Battery

If sufficient concentrations of gas are detected, this gas detector sounds an alarm (4 rapid beats) and closes the gas valve, stopping the flow of gas to the protected appliance(s). Alarm sounds continuously until manually shut off. Gas valve remains closed until (1) the detector is reset and (2) gas vapors are no longer present. Before reset, the affected area must be ventilated. If gas remains when reset, the alarm will sound again. Have a qualified LP Dealer or Natural Gas Company locate the leak and make the necessary repairs.

How to Operate:

When gas service is required, turn the gas detector on (slide switch up to ON position). A pinging or ticking sound occurs: Warm-Up and Self-Check Mode. After 60 seconds, the green indicator lights: the gas valve is open from the gas source to the gas appliance. Light any pilot lights. To turn off detector, slide the switch to the OFF position (Gas Flow is Stopped).

CCI Gas Leak Detector Includes Gas Valve Controlled by Solenoid,Gas Alarm or Gas Detector, Back-Up Battery and Battery Housing. Increase Gas Safety by Installing this Safety Gas Valve on Your Gas Appliances.

CCI Gas Leak Detector Includes Gas Valve Controlled by Solenoid,Gas Alarm or Gas Detector, Back-Up Battery and Battery Housing. Increase Gas Safety by Installing this Safety Gas Valve on Your Gas Appliances.

Mount the gas detector so that air is drawn in the front and flows freely through the back.
This safety device mus be plugged into a non-switched outle. The unit requires constant power for battery to remain charged.
Use one detector per 20 x 20 foot room.
Mount unit near to gas appliances such as water heater, stove,dryer, etc.
Mounting Heights: Natural Gas = 4" from the ceiling. Propane Gas = 4" from the floor.
Self check circuit: Continuous testing when detector is on. If circuit fails: alarm sounds short beep every 45 seconds and fault indicator light flashes.

Specifications:

Power Supply: 110V AC (wall adaptor supplied). Optional 220V AC model.(special order).
Battery Backup: 12 V rechargeable battery maintains detector's operation up to 5 hours if power fails.
Operating Temperature: Methane: 32° to 120° F Propane=0° to 120°
Storage Temperature: -31° to 150° F
Alarm Threshold: 20% LFL Methane (10,000 ppm) or 20% LFL Propane (4000 ppm).
Alarm Output: Audible - 85dB; Visual - Flashing RED Indicator.
Valve Control: Controls gas solenoid valve (supplied)
Case Construction: ABS Plastic. Meets UL 94-V(0).
Options: Relay, Signal, Control Outputs (call for further information).
Dimensions: Methane: 7.25" wide x 4" tall x 5" deep.
Propane: 7.2" wide x 4.1" tall x 5.6" deep.
1 Year Manufacturer's Limited Warranty