Automatic Water Shut Off
Lower insurance premiums. Protect against water damage with this automatic water water shut off system with moisture sensors. For 3/4 inch water pipes, install this Water Cop 3/4 Inch Brass Ball Valve Automatic Water Shut Off Valve Starter Kit with Security Alarm Interface and 3 Moisture Sensors. An undetected slow or fast water leak can cost thousands in repairs plus inconvenience and higher insurance premiums. WaterCop "Sergeant" Basic Automatic Package Kit: Water Cop Automatic Actuator with 3/4 Inch Brass Ball Valve and Home Security Interface and three (3) Single Probe Water Hound Moisture Sensors. Built-in I/O port with RJ45 connection. |
| Water Cop Installation Locations: | After existing main water line shut off valve or inside building if shut-off is outside. Maximum working water pressure is 125 PSIG. |
| Installation Time: | Professional installation: one to two hours+. For new dwellings, install WaterCop Ready Water Valves and add WaterCop later. |
| WaterCop Power Requirements: | 120VAC electrical outlet. outlet. |
| Water Cop Security System Option: | Low voltage interface terminal direct wires to home security alarm system or home automation control panel. For security systems with auxiliary outputs, contact security system dealer/installer for interface installation. |
WaterHounds: - Local Water Alarm for Moisture
- Transmit Signals for to Activate Your WaterCop.
- For Maximum Water Leak Detection, Place Water Hound Water Alarm Near Every Water Using Appliance.
| - Power Source: 2 AA Batteries (Not Included) or AC Power Adapter (Not Included)
- Operational Modes: WaterCop Activation Device Plus Independent Moisture Sensing Water Alarm
- Alarm Intensity: Similar to Watch Alarm or Pager
- Single Probe: One 9.75 Ft. Cord and One Transmitter/Alarm
- Twin Probe: Two 9.75 Ft. Cords and One Transmitter/Alarm
- Operational Distance from WaterCop: Up to 200 Feet. Frequency goes thru sheetrock and concrete. Significant metal construction may reduce range. Suggestion: test WaterCop range for water leak detection before installation.
|
| Starter Kit Contents: | WaterCop and Three Water Hounds (Single Probe) to monitor washing machine, hot water heater, refrigerator or dishwasher. |
| Additional Sensors Available: | WaterCop supports an unlimited number of WaterHounds for water leak detection. |
| Additional WaterCop Valves: | "Zoned" protection for large houses or buildings. |
| NOTE to Contractors: Install WaterCop Ready Water Valves. | Inexpensive. Add WaterCop later with a few screws. |
| Leak Detection Sensor Specifics: | - Sensor probe contacts: gold-plated for reliability.
- Frequency; 400 - 500 MHz. At trade shows, there was no interference with other FM frequencies.
- Change communication codes: Dip switches on sensors and receivers. 4 switches; 48 possible codes means 48 possible zones with additional WaterCop valves.
- Battery Life: Alkaline about 1 year. Titanium, about 2 years.
- Low battery: units "chirp."
|
| Notes: | - Manual override for closed valve. If power fails, unscrew and remove water valve actuator and turn valve stem with wrench 1/4 turn.
|
| Warranty: | One Year Manufacturer's Warranty. |
HTML
PDF