Protect your home or business against water damage from leaking washer machines, refrigerators, dishwashers and more. Install the WaterCop Automatic Water Shut Off Valve Starter Kit, the Sergeant with 1/2 Inch Brass Ball Valve and Security Alarm Interface and three single probe water alarms. This electric water valve responds to radio signals from water alarms placed under or near water using appliances and shuts off the water to that zone or the entire building. Contents: Water Cop Automatic Actuator with 1/2 Inch Full Port Brass Ball Valve and Home Security Interface and three (3) Single Probe Water Hound Moisture Sensors. Built-in I/O port with RJ45 connection. |
| Water Cop Installation Locations: | After existing main water line shut off valve or inside building if shut-off is outside. Maximum working water pressure is 125 PSIG. |
| Installation Time: | Professional installation: one to two hours+. For new dwellings, install WaterCop Ready Water Valves and add WaterCop later. |
| WaterCop Power Requirements: | 120VAC electrical outlet. outlet. |
| Water Cop Security System Option: | Low voltage interface terminal direct wires to home security alarm system or home automation control panel. For security systems with auxiliary outputs, contact security system dealer/installer for interface installation. |
WaterHounds: - Local Water Alarm for Moisture
- Transmit Signals for to Activate Your WaterCop.
- For Maximum Water Leak Detection, Place Water Hound Water Alarm Near Every Water Using Appliance.
| - Power Source: 2 AA Batteries (Not Included) or AC Power Adapter (Not Included)
- Operational Modes: WaterCop Activation Device Plus Independent Moisture Sensing Water Alarm
- Alarm Intensity: Similar to Watch Alarm or Pager
- Single Probe: One 9.75 Ft. Cord and One Transmitter/Alarm
- Twin Probe: Two 9.75 Ft. Cords and One Transmitter/Alarm
- Operational Distance from WaterCop: Up to 200 Feet. Frequency goes thru sheetrock and concrete. Significant metal construction may reduce range. Suggestion: test WaterCop range for water leak detection before installation.
|
| Starter Kit Contents: | WaterCop and Three Water Hounds (Single Probe) to monitor washing machine, hot water heater, refrigerator or dishwasher. |
| Additional Sensors Available: | WaterCop supports an unlimited number of WaterHounds for water leak detection. |
| Additional WaterCop Valves: | "Zoned" protection for large houses or buildings. |
| NOTE to Contractors: Install WaterCop Ready Water Valves. | Inexpensive. Add WaterCop later with a few screws. |
| Leak Detection Sensor Specifics: | - Sensor probe contacts: gold-plated for reliability.
- Frequency; 400 - 500 MHz. At trade shows, there was no interference with other FM frequencies.
- Change communication codes: Dip switches on sensors and receivers. 4 switches; 48 possible codes means 48 possible zones with additional WaterCop valves.
- Battery Life: Alkaline about 1 year. Titanium, about 2 years.
- Low battery: units "chirp."
|
| Notes: | - Manual override for closed valve. If power fails, unscrew and remove water valve actuator and turn valve stem with wrench 1/4 turn.
- Pair an Alarm Ready WaterCop with TemperatureGuard Plus. Click here for more information. Units monitor water valve closure, power status, and temperature changes via phone or page alerts.
|
| Warranty: | One Year Manufacturer's Warranty. |
![[Home]](/shp2/data/menus/Non-framed_6/SHP_NF_m1_i0.png){kind=small}
HTML
PDF