Cardinal Gates - Kids Edge GRAY Hearth Pad, Metal Frame, Up to 78 in.
Gray Kids Edge Hearth Guard With Metal Frame For Standard Rectangular Hearth with Two 90 Degree Angles. Fits a Fire Place Hearth Up to 78 Inches Long with Two Returns 8-18 Inches Long.
Attach this wider, longer edge padding to the three telescoping metal frame pieces to childproof the front of standard rectangular fire place hearths. The metal frame means no sticky adhesive residue on bricks or stones if you remove the hearth guard. The metal frame also means easy removal and re-installation for cleaning.
Kids Edge Hearth Guard Pads provide fire-resistant, non-toxic, dense, impact absorbent padding to prevent injuries from falls against sharp corners and edges of hearths. Gray pad blends with most brick, stone, marble, and slate surfaces.
Gray Hearthguard with Metal Frame Child Safety Features:
Patented sturdy telescoping three part metal frame: Two end pieces expand from 8 to 18 inches. One center piece expands from 54 to 78 inches. with lab tested fire resistant pad.
Safe, dense, impact-absorbing non-toxic, lab tested fire resistant padding: 2 3/8" x 2 3/8" lip for better protection. Pads will smolder, not burn.
Easy application and removal: Pad is fastened with adhesive to a metal frame which clamps firmly to hearth. No adhesive residue on hearth itself.
Cleaning Ease: durable, easily cleaned padding. Remove entire unit for cleaning the slate or brick hearth.
Color: Gray. Available in black, ivory or brown in lengths to fit up to 78 inch wide hearth front. Taupe is available for up to a 92 inch hearth front.
Optional Length Extension : 24 inches includes metal frame and padding.
One metal telescoping frame piece that extends from 54 to 78 inches
Two metal telescoping frame pieces that extend from 8 to 18 inches. Note: To use this metal frame, a hearth must have two returns measuring 8 to 18 inches.
Instructions and adhesive tape.
Note: Most hearth pad pieces come attached to the metal frame. Only the center pad needs to be attached on the long frame piece prior to installation.
INSTALLING UNIT ON HEARTH with METAL BACKING This hearth guard device consists of two sections. The left side is completely covered with pad. The right side, which is partially covered with pad, slides under the left side for adjustment. Now extend sections of unit and place on hearth. Pull section together until snug on hearth. Without allowing sections to slide, remove unit and turn over to expose tightening rod (6). Insert rod hook into nearest hole and pull sections apart so there is enough tension to keep the hook in hole. Reposition unit on hearth. Insert Phillips screwdriver into hole at right corner (3). Turn tightening bolt clockwise until tension is felt. Now, ensure that unit is in place by pushing down and back at corners. Tighten bolt further until unit is secure on hearth. (NOTE: if unit is not secure and tightening bolt will not turn further, then loosen bolt, remove unit and move adjustment hook to next hole. Now reinstall unit.) CAUTION: IT IS POSSIBLE TO TIGHTEN BOLT TOO MUCH CAUSING ENDS TO FLARE OUT CAUSING LOSS OF GRIP .
For longer hearths, purchase the OPTIONAL Length Extension: 24" Length Extension (metal backing and pad)
