Use it when a flood, water repairs or hurricane is predicted that could interrupt a
safe water supply . Use the included pump to remove water as needed. The Aqua Pod Kit Deluxe has 3 disposable liners and a reusable pump. This water storage kit made of a low density polyethylene bag and a manual hand pump is a practical way to solve emergency storage needs without buying, carrying and storing 65 gallons of bottled water.
Beware of using fire truck storage tanks or previously used cans or bottles for water storage: contamination with microbes or chemicals is possible. Plastic jugs or cardboard containers previously used for milk or fruit juice are like petri dishes in a lab: Milk protein and fruit sugars lingering in these containers provide an environment for bacterial growth when used for water storage. Don't take the risk. Keep your emergency water supply in a closed system designed for safe water storage and water distribution.
Remember, you need water to wash and to flush toilets as well as for cooking and cleaning.
Each Aqua Pod Deluxe Kit Contains: - 3 disposable tub liners, each 40 inches by 80 inches. This will fit in a Jacuzzi tub or standard 5 feet tub. An average tub holds 70 gallons.
- 3 disposable tie clamps to hold the bag to water spigot during approximate 10 minute time that it takes to fill the bag. (Dependent upon water pressure.)
- 1 reusable pump with locking system. Locks the pump to the liner bag.
- FDA approved plastic,LDPE Plastic. Low Density Polyethylene Plastic.
- Shelf Life: Up to 10 years depending upon storage.
- Made in the USA.
Instructions for Use:
- Place liner in tub with liner neck positioned near tub spout.
Secure the liner neck to the tub spout with one of the enclosed tie
clamps.
- The tub liner can be filled to within a couple of inches of the tub’s top rim. DO NOT OVER FILL.
- Pull liner neck through inner sleeve.
- Pull and fold liner over top part of inner sleeve (see printed PDF of instructions).
- Push outer sleeve over the liner that is wrapped over the inner sleeve.
- Place sleeve cap over outer sleeve and snap into place.
- Insert the pump siphon tube into the sleeve cap.
- Snap pump siphon tube into sleeve cap so it fits evenly and tight. Make sure that the sleeve cap is on securely.
- Place cork (discharge tube stopper) in to the discharge tube. At this point the water is stored.
- To dispense the stored water, remove cork and place the discharge
tube into a container. Turn top knob to the on position. Begin pumping
the water by squeezing the pump bulb. Place cork in discharge tube to
store for next usage.
Additional Important Information:
Liners are for one-time use only! The tub liner must be properly
discarded and not reused. If reused, the stored water may be
contaminated. AquaPodKit will not be held responsible for improper use
or use outside the guidelines of these instructions. Use pump only as
intended with this product. The pump may be reused with a tub liner
refill kit.
WARNING: If the tub liner bag has been damaged in any way or flooding
levels were above the top of the tub, DO NOT USE the stored water for
consumption or hygiene. Follow the guidelines published by the FEMA or
your local emergency management office on water purification processes.
Kit contains small parts and sheet plastic which can present a choking
hazard. KEEP OUT OF REACH OF CHILDREN
HTML
PDF
