aquapodmanual

Instructions for AquaPod Kit

Kit contains:

1 disposable tub liner

2 disposable tie clamps 1 reusable pump

1. Place liner in tub with liner neck positioned near tub spout. Secure the liner neck to the tub spout with one of the enclosed tie clamps.

2. 2. The tub liner can be filled to within a couple of inches of the tub's top rim. Do not over fill.

3. When adequately filled, cut the tie clamp and insert the pump into the tub liner through the neck opening. Secure the liner neck to the top of the pump siphon tube using the remaining tie clamp.

4. Insert the pump discharge tube stopper into the end of the pump discharge tube. Make sure that the vent cap is fully closed. At this point the water is stored.

5. To dispense the stored water, remove the discharge tube stopper and place the discharge tube into a container. Begin pumping the water by squeezing the pump bulb. Repeat step 4 to prepare the pump for storage.

Additional Information:

The tub liner must be properly discarded and not reused. If reused, the stored water may be contaminated. AquaPodKit will not be held responsible for improper use or use outside the guidelines of this instruction.

Use pump only as intended with this product. The pump may be reused with a tub liner refill kit.

Warning :

If the tub liner bag has been damaged in any way or flooding levels were above the top of the tub, DO NOT USE the stored water for consumption or hygiene. Follow the guidelines published by the FEMA or your local emergency management office on water purification processes.



	Instructions for AquaPod Kit Kit contains: 1 disposable tub liner 2 disposable tie clamps 1 reusable pump 1. Place liner in tub with liner neck positioned near tub spout. Secure the liner neck to the tub spout with one of the enclosed tie clamps. 2. 2. The tub liner can be filled to within a couple of inches of the tub's top rim. Do not over fill. 3. When adequately filled, cut the tie clamp and insert the pump into the tub liner through the neck opening. Secure the liner neck to the top of the pump siphon tube using the remaining tie clamp. 4. Insert the pump discharge tube stopper into the end of the pump discharge tube. Make sure that the vent cap is fully closed. At this point the water is stored. 5. To dispense the stored water, remove the discharge tube stopper and place the discharge tube into a container. Begin pumping the water by squeezing the pump bulb. Repeat step 4 to prepare the pump for storage. Additional Information: The tub liner must be properly discarded and not reused. If reused, the stored water may be contaminated. AquaPodKit will not be held responsible for improper use or use outside the guidelines of this instruction. Use pump only as intended with this product. The pump may be reused with a tub liner refill kit. *Warning :* If the tub liner bag has been damaged in any way or flooding levels were above the top of the tub, DO NOT USE the stored water for consumption or hygiene. Follow the guidelines published by the FEMA or your local emergency management office on water purification processes.